Eden Autopro
2625a St Johns St Port Moody, BC V3H 2B5 604-937-5531

Many Port Moody drivers hear the term “Oxygen Sensor” and figure it must have something to do with sensing oxygen, but don’t really know much beyond that. Let’s break it down: your vehicle has an oxygen sensor in the exhaust manifold that measures how much unburned oxygen there is in the exhaust. The sensor reports its findings to the engine control unit (ECU), which knows how much oxygen there should be in the exhaust. Based on that information, the ECU will adjust the amount of fuel it sends to the engine.

This feedback and adjustment loop is non-stop. The goal is to have the optimal air to fuel ratio for performance, efficiency and to lower harmful emissions. 

Now there is a second oxygen sensor located in the exhaust pipe after the catalytic converter. It too measures the amount of oxygen in the exhaust after it has been treated by the catalytic converter. As this measurement is reported back to the ECU, the computer compares the oxygen levels before and after the catalytic converter to determine if the converter is still functioning properly.

So, 4-cylinder vehicles have two oxygen sensors. V-6 and V-8 engines have four sensors, two for each bank of cylinders. As you can imagine, the oxygen sensor lives and functions in a pretty hot environment so they do wear out over time. Substances in the exhaust can also damage them leading to failure. Outside elements like water and road salt can corrode an oxygen sensor. When the sensor goes bad it simply needs to be replaced.

BC drivers may be interested to know that oxygen sensors are often replaced needlessly. When the oxygen sensor returns a measurement that is out of the specified range, it may trigger a trouble code in the ECU and the Check Engine Light is illuminated. Inexperienced do-it-yourselfers may read a trouble code that reports an out of range sensor reading. That could mean that the sensor is bad, but it could also mean that the sensor is accurately reporting a condition caused by some other malfunction. A skilled diagnostician can sort this out and will only replace the oxygen sensor when it has truly failed.

When you have a Check Engine Light come on and stay on, it’s good advice to have it diagnosed by a qualified technician. The cause may be minor or quite significant, so it’s best to play it safe and let the professionals weigh in.

Stop by or give us a call.
604-937-5531

Eden Autopro
2625a St Johns St
Port Moody, BC V3H 2B5
http://edenautomotive.ca


At Eden Autopro we install quality NAPA replacement parts.